I made a set of useful PCBs. They are intended to mount large (big really big) film capacitors: WIMA DC Link ones!
I use the cost-effective 45μF/600V (MF Part No. DCP4I054507ID2KYSD) in many of my boards as the last capacitor in the filtering network. This is a 2 pin device, however when you go larger like the 80μF/900V (MF Part No. DCP4N058009JD4KYSD), this one has 4 pins and bigger size. The PCB for the later can also accommodate the smaller DC Link of 45μF/600V. The boards have turret or 2mm banana plug connections and an INS-1 Nixie indicator with its associated resistor. Finally a bleeder 3-5W resistor can be added.
The smaller board has the size of the Source Follower PCB. It can be mounted below it or can be used independently. Can fit a variety of PIO/Film capacitors for decoupling or for AC interstage coupling.
Speaking about the Source Follower PCB, I made also a new batch of PCBs as run out of the original ones. I made a minor modification and improvement by adding an LED indicator before the top MOSFET drain. This works in the same way as the gyrator Rev08 PCB. Can be used for normal operation or for A2 current source indicator. Also added an extra PIO/Film 100nF decoupling cap to be mounted under the PCB to decouple the high impedance node to the power supply:
