Tag: Sic filament bias

The low gain DHT pre-amp library

For more than 10 years I’ve been experimenting, designing and enjoying DHT pre-amps. Without over-dwelling on this subject, to me DHT preamps bring the unique sound transparency and detail we all seek for. They can make night or day difference in any system. And is not about gain, hence I’m focusing on sharing this blog entry.

Continue reading “The low gain DHT pre-amp library”

Aa DHT Preamp (Part I)

Obviously it was time to test the little brother of the “Ba” DHT. In particular, as I have such a low DAC in place now, I need the gain. With nearly a gain of 30, it’s an attractive fellow to work with.

First good sign is that it doesn’t pick up as much hum as the Ba. That’s good, nevertheless I placed a back copper plate which acts as enough earth shielding to keep the Ba quiet.

I worked with my breadboard to find a good “sweetspot”( at least electrically) for this valve. Given the low signal source level, I aimed for a low bias. I played with my fixed bias setup before replacing it with the SiC bias board. I found that 2V/160V was very good in terms of keeping the distortion profile to minimum. Here is what I ended up with:

Only 2 SiC diodes are enough. The source follower PCB is mandatory given the low anode current. I run it at 20mA (hot) to get best results of the stage. Rest of the circuit is very simple, achieving a gain of about 30. Here is the distortion profile:

There is no shielding and you can see some minor IM distortion with mains hum. Harmonic decay is nice with H2 being strongest. THD is very low at 4Vrms which is good sign. Let’s see the frequency response now:


Nearly 140kHz of bandwidth which is plenty for the stage. Great response. I just need to plug this one in and listen to this promising German DHT.

 

01a with filament SiC bias

I tried the below configuration and the results are very promising.  Sound is as good as previously implemented SiC cathode bias.

Now looking at the TH and frequency response:

The stage performs as expected. I built some prototype PCB for the SiC filament bias. One board per channel. If there is any interest, I will run a bigger batch

 

Sounds great, as always.

Cheers

Ale

 

Ba DHT Preamp Build

Just in the last days before the arrival of our second child, I had a spot of luck and managed to get some free time to work on my DHT preamp experiments. 

A pair of NOS Siemens “Ba” valves under initial testing 

Originally I was put off by the hum pickup susceptibility of the Ba German DHT. However, I decided it was time to listen to the design I worked and experimented in my workshop time ago. I remember listening to this valve and was very pleased with its sound. 

Continue reading “Ba DHT Preamp Build”