46 DHT in triode mode as a driver

Continuing with the design of the 4-65A SE amplifier based on M. Koster design, I’m in the process of tweaking the 46 driver to optimise the operating point and provide maximum distortion to drive the demanding 4-65a. Here is the circuit I’m currently working on.

The current 46 driver will be biased at around 25-30mA using filament bias, so Vgk will be around -16 to -17.5V using a 10Ω filament bias resistor array. This will set the 46 at around 185-210V which will give sufficient headroom (i.e. need about 200Vpp max) to drive the 4-65a.

So today I look at varying slightly both anode currents and Vgk to see impact on THD.

So minimum THD is around -17V and Ia=30mA. So if setting the Rod Coleman filament regulator to ensure that Vgk=-17V and the anode gyrator to set anode voltage to ensure Ia is close to bias current would provide the minimum distortion (which is 0.04% in this example). Pa is close to 7W, but looking at the datasheet we can see that maximum Pa is 10W (as the latter 45 version).

 

So next I need to build a prototype of this driver with filament regulator and gyrator load.