Tag: 112a DHT preamp

01a Low Gain DHT preamp

How many times I’ve been asked “how do I lower the gain of the DHT preamp?” many builders love the DHT sound and yet don’t really need that gain. Of course when you use a transformer load, step down is the obvious choice. And it works really well when you invest in a very good quality OPT.

However, when you use DHT with high rp, generally most of the low current ones, you face a tough challenge with regard to frequency response.

With the hybrid mu-follower topology (aka gyrator) we have the problem that the gain is fixed to nearly mu.

I’m in love with the DHT sound and in a preamp a 01a and the 801a/VT-25 DHT Preamp Update preamp cannot be beaten in my view. They all deliver a gain of 8 with a hybrid mu-follower topology.

This can be overcome in the following way: Continue reading “01a Low Gain DHT preamp”

cx-112a DHT preamp

Introduction

This was one of my first DHT preamps. I found a quartet of NOS CX-112a Cunningham (globe) back in Buenos Aires many years ago and built one of my first DHT preamps. I loved it. I played with it before I moved into the 26 and then started the long exploratory journey with DHTs. 

The CX-112a can be easily fit in an existing 01a preamp. Take a look at what Thomas Mayer recently blogged about this valve, worth reading it. 

Well, you can get more current drive than 01a (nearly double) but no thoriated tungsten filaments. Anyhow, the gain is slightly higher but is very easy to adapt to my gyrator-based circuit, that I couldn’t resist to take the quartet out of my valve stash and make them sing again after so many years.

Continue reading “cx-112a DHT preamp”