DHT preamp “The Mule”

The birth of the Mule

The name I guess says it all. This is yet another DHT preamp with the gyrator PCB. So what’s different? Simply, a breadboard DHT preamp module ready to be abused.  I’m planning to mod this to death and try a long list of other DHTs with the gyrator load. 

I will only need to change the valve sockets (or build an adaptor) as well as the filament resistors and Rod Coleman filament regulators. Simple changes which can be done fast, will open the door to quick tests on my system.

In order to make this simple and a rapid build, I opted to use an IKEA chopping board. These are made of a laminated hardwood and are dirt cheap. A couple of hours are required to drill all the board like this:

Job done. You only need to do this once. Here is another look at the half-build Mule:

The initial sockets are NOS short pin UX-4/UV-4. I will play around with the 01a before I move to other DHTs. I still need to add the tag strips for filament resistors, output capacitors and the filament regulators. 

Wiring will take a couple of hours and we should have another DHT amp to play with 🙂

 

SiC MOSFET Follower Driver

How many more times

Led Zeppelin wrote a fantastic song on their first album: how many more times. You may not be a rock fan, but hey: what a great song. How many more times do I want to get back to this “slew rate” theme? I don’t know, as much as I have to. Plenty of comments out there of bad designs with wimpy drivers attempting to take the 300B/2A3 or even 45 valves to full tilt with disappointing results. Either way, they always blame the valves.

I came back to revisit the driving of capacitive loads effectively as I’m working on a new 4P1L PSE amplifier. Slowly, but getting there. Previously I looked at adding a buffer to the 01a preamp as a result of slew rate limitations found in Tony’s implementation of this preamp.

buffer

 

 

The circuit design

Continue reading “SiC MOSFET Follower Driver”