Tag: line stage

A (not that simple) line stage

Thanks to Tim’s suggestion to implement Allen Wright’s Super Linear Cathode Follower (SLCF) which forces the valve to operate in constant voltage (in addition to the constant current) by bootstrapping the cathode to the anode using an extra follower, distortion is reduced further. In my case, it is halved!

The “extra follower” on top of the cathode follower could be another valve. But to avoid elevating heating, I just went for a straight sanded follower using a depletion FET, the famous DN2540. You can use the MOSFET of your choice here:

LME49830 buffer v04The stage gets a tad more complex, albeit not much. We can keep one single supply rail here but we need to elevate HT up to 180V minimum to provide the headroom required by the FET to operate well and minimise its output capacitances to ensure HF response is good. M1 is the top follower which provides a fixed DC voltage using the resistor divider formed by R7 and R8. The higher these are in value the smaller C4 is. C4 provides the bootstrapping between cathode and anode to force constant voltage operation at all times. This minimises the distortion of the valve. I found that 100nF was enough to halve the distortion down to 0.0035% at 2Vrms!

PSR is about 60 to 70dB across the audio band so great addition to have a top active device here!

I think this could be a fantastic follower to use in multiple designs. Worth breadboarding it, hopefully shortly.

 

A simple line stage

Driving your amp

A typical challenge we may all face is how to drive effectively our amp via a stepped attenuator or an AVC. I have a 4P1L preamp which drives very well my AVC, however, I have now an LME amp which has a wimpy input impedance of less than 7K.

How do we deal with this? A simple line stage which is capable of driving the low impedance of the amp is what we need in this case. Several options are available, however I settled down for a simple cathode follower.

Why? Because I love valves, and I wanted to play around a cathode follower design here.

vinilo A heavy load for your preamp or music source may increase distortion and we don’t want that.

I set myself the challenge to design a simple linestage with a minimum number of power supplies. I could have gone for a MOSFET follower, but hey: I wanted some hollow state stuff in there! Ok, if we look into a cathode follower as the core design, this means that we need at least an HT supply and a filament supply. If we could leverage a bucket converter, we could provide the HT from a LT transformer, probably best to look into two windings to separate the filament supply from an HT one. There are cheap ready build step-up converters for peanuts, and this is what tempted me to explore this solution.

I tested recently some step-down bucket converters and was encouraged by the noise levels and the FR.

The first design, getting us started

Continue reading “A simple line stage”