On my previous post, I covered my initial build work on the gyrator test mule using the gyrator PCB. I did all the lovely soldering work (which I do enjoy not like milling or drilling) and proceeded to do several tests.
Some interesting observations based on my abuse of the gyrator which yielded on several MOSFETs and JFET damaged as a result:
- CCS reference: I used an external multi turn 5KΩ potentiometer via lead cables. I wired it incorrectly and that contributed to one of the initial faults. Be sure you look carefully on this if you use an external pot. if you use the on-board trimpot, this is not an issue.
- JFET: this is the interesting one. If you want to run the lower JFET at very low biasing current for a larger jFET (e.g. J310) you will find that the JFET needs to operate close to cut-off voltage (somewhere between -2 and -6V). This VGS required will definitely forward bias the Zener protection diode D1 and prevent from reaching lower bias current (I found it about 10mA for J310). To resolve this you just need to add a back to back zener as shown below. This isn’t a problem for an BF862 or a 2SK170 as their cut-off voltages are quite small.
- Failure: if you abuse the FETs, they will die. And if they die you will get a nice short across them and you will measure nearly HT at the mu output. Just replace the MOSFET and JFET (probably both are damaged)
